The capacitors are designed for power factor correction and harmonics filtration in power network.
They are all-film dielectric and impregnated with an environmentally friendly, Non-PCB biodegradable insulating oil.
In addition each capacitor is provided with an internal discharge resistor.
All SAMWHA capacitors comply with most national and international capacitor standards.
Capacitor benefits to - Improve Power Factor
- Reduce Line Losses
- Decrease Voltage Drop
Through that it helps greater Energy Efficiency
- Power Range Single Phase 25kvar to 1000kvar
Three Phase 50kvar to 500kvar
- Voltage Range Single Phase 1000V to 22000V
Three Phase 1000V to 11000V
- Frequency 50Hz / 60Hz
- Applicable Standards IEC, ANSI / IEEE, NEMA
Capacitor Loss
(Under Stabilized Condition)		 0.2W/kvar or Less with Internal fuse
0.15W/kvar or Less without Internal fuse
Ambient Temperature -40¡É / A (+40¡É), B (+45¡É), C (+50¡É), D (+55¡É)
Max overvoltage Umax UN + 10% (up to 8 hours daily)
UN + 15% (up to 30 minutes daily)
UN + 20% (up to 5 minutes)
UN + 30% (up to 1 minute)
Max overcurrent IS 1.3 ¡¿ IN
Painting Color Munsell No. 5Y 7/1
Reference Standard IEC 60871
BIL(kV) Creepage
Distance
(mm)		 Strike
Distance
(mm)		 Total
Height
(mm)		 60Hz Withstand Weight(kg)
Dry Test(kV) Wet Test(kV)
60 191 109.2 188.1 60 45 0.87
75 191 109.2 188.1 60 45 0.87
95 318 162.6 235.6 70 55 1.23
150 438 193.0 266.8 80 60 1.75
175 635 223.5 287.9 90 70 2.14
200 720 302.4 388.9 100 80 2.79
* The standard terminal sieze is M12, but M16 could be applied according to rated voltage.
* Same Bushing is used on 60 and 75kV BIL of capacitor units.
* Bird Cap and Parallel-groove connector with all bushings is supplied, and it is applicable to Copper or Aluminum conductor (14~100§± 2line)
* Applied bushing could be changed by special requirements.